Plotting in Serpent 2

Compiler issues (Intel compiler, mpicc, etc.), data libraries and everything needed to get Serpent running is discussed here
Post Reply
r.aldred
Posts: 1
Joined: Mon Nov 18, 2019 6:39 pm
Security question 1: No
Security question 2: 7

Plotting in Serpent 2

Post by r.aldred » Mon Nov 18, 2019 6:46 pm

Hello,

I have recently compiled Serpent 2 and have been following the introductory tutorial on the wiki to plot the 2D pin-cell. However when I run 'sss2 -plot pin', nothing is plotted and Serpent instead launches into calculations.

I have compiled Serpent using gcc version 4.4.7 and the -DNO_GFX_MODE flag (as the GD graphics library is not available). The header information states that "- Geometry and mesh plotting available".

Please can you give some guidance regarding why the plotting option is not working?

Thanks,

Ruth

User avatar
Jaakko Leppänen
Site Admin
Posts: 2388
Joined: Thu Mar 18, 2010 10:43 pm
Security question 2: 0
Location: Espoo, Finland
Contact:

Re: Plotting in Serpent 2

Post by Jaakko Leppänen » Tue Nov 19, 2019 9:20 am

The plotting option is probably not working because the -DNO_GFX_MODE flag disables it. You may get the message that the option is still available if the source code is not fully compiled. Whenever you make changes in the Makefile, you should do a "make clean" before "make".
- Jaakko

Post Reply