Page 1 of 1

Split Cell Locations and Detectors

Posted: Fri Mar 24, 2017 5:18 pm
by jesse.johns
Hello,

I was looking through the source on an easy way to locate spilt regions... basically, I wanted to print out all of the points that come from the checkvolumes routine so that I can compute the center of mass of each new region. The hope here, is that externally, I can correlate results from Serpent II, after I've done automated splitting, to some post-processing tools that I have.

I'm not sure if what I'm proposing the is the best way to go about this, but my lattice is nested and a bit complex.

Any thoughts?

Thanks!

Jesse