Realizing a detector for burnup materials

Questions, comments and complaints about the User's Manual
Post Reply
aizen
Posts: 2
Joined: Sun Apr 01, 2012 2:00 pm
Security question 1: No
Security question 2: 92

Realizing a detector for burnup materials

Post by aizen » Mon Jun 25, 2012 6:08 pm

hi

i would like to ask for instructions for writing a detector when the material is used for burnup calculations.
i understand that the name change but i can't figure out how to name it now.

thank you

User avatar
Jaakko Leppänen
Site Admin
Posts: 2440
Joined: Thu Mar 18, 2010 10:43 pm
Security question 2: 0
Location: Espoo, Finland
Contact:

Re: Realizing a detector for burnup materials

Post by Jaakko Leppänen » Tue Jun 26, 2012 1:31 pm

If burnable material "<mat>" is used in a pin-structure, the code renames it as "<mat>p<n>r<m>", where <n> is the pin index (= universe number) and <m> is the ring index (if the material was divided into multiple rings by entering a value greater than 1 after the "burn" entry in the material card). You should be able to use this name in the detector calculation. Also see Sec. 7.3 and 8.2 in Serpent manual.
- Jaakko

Post Reply